Mazda 1990 323 Workshop Manual Supplement page 161

TRANSAXLE AND TRANSFER UNIT
J3
r
03UOJ3-1E i 3
03UOJ3-164
03UOJ3-165
tw
03UOJ3-16;
Reverse idler gear shaft assembly
Caution
l
Verify that the gears are properly engaged.
1. Align the lock bolt hole and mark of the clutch housing.
Interlock pin
1. Install the interlock pins as shown in the figure.
Top cover assembly
1. Install the steel balls and the springs.
2. Install the top cover.
3. Install the boot with the air bleed downward as shown in
the figure.
Transaxle case assembly
1. Apply a thin coat of sealant to the contact surfaces of the
clutch housing and transaxle case.
2. Install and tighten the transaxle case installation bolts to the
specified torque.
Tightening torque:
37-52 N-m (3.8-5.3 m-kg, 27-38 ft-lb)
J3-a3