Mazda 1990 323 Workshop Manual Supplement page 401

TRANSAXLEANDTRANSFERUNIT
K2
CONTROL VALVE BODY (ASSEMBLY)
Assembly
Caution
c
l
Before assembly, make sure all parts are perfectly clean.
l
Apply ATF to all parts.
l
Do not reuse the gaskets or O-rings.
1. Assemble as shown in the figure, referring to
Assembly Procedure.
(3
O-RING, NEW
1. Oil strainer
10. Main/rear front gasket
2. Lockup solenoid valve
Il. Orifice check valve and spring
3. Oil strainer
4. 3-4 solenoid valve
5. Rear control valve body
Bolt installation position . . . . . . . . . . page K2-229
6. Orifice check valve and spring
Installation position .,............... page K2-228
7. Orifice check valve and spring
Installation
position . . . . . . . . . . . . . . . . . page K2-228
8. Main/rear rear gasket
9. Rear separator
Installation position ..,.............. page K2-228
12. Steel ball
Installation position ..,.............. page K2-228
13. Main control valve body
Bolt installation position . . . . . . . . page K2-229
14. Orifice check valve and spring
Installation position . . . . . . . . . . . .
page K2-228
15. Converter relief ball and spring
Installation
position . . . . . . . . . . . . . . . . . page K2-228
16. Premainlmain rear gasket
K2-225