53
TRANSAXLE
AND TRANSFER
UNIT
I
03UOJ3-14
03UOJ3-145
,
,
II
03UOJ3-146
03UOJ3-1
Front and center differential
1. Install the bearing outer race with the SST.
2. Install the front and center differential and bearing outer race.
3. Set the SST (selector) in place.
4. Set the SST (collars) between the transaxle case and the
clutch housing, and install the SST (bolts), and tighten to
the specified torque.
Tightening
torque:
37-52
N,m (3.8-5.3
m-kg, 27-38
ft-lb)
.- /
5. Seat the bearings by turning the SST (selector) with the SST
(bar) until the gap is enlarged.
6. Insert the SST.
7. Expand the SST (selector) until the proper preload specifi-
cation is obtained.
Preload:
0.3-l
.2 N-m (3-12
cm-kg, 2.6-10.4
in-lb)
03UOJ3-148
J3-76