Mazda 1990 323 Workshop Manual Supplement page 525

ENGINE SPEED SENSING POWER STEERING
N
03UONX-816
03UONX-817
03UONX-818
03UONX-819
6. Separate the front of propeller shaft.
7. Lower the engine gradually until the lower left mounting bolt
can be removed.
Caution
l
Do not tower
the
engine too much because it wiH
damage the
front left driveshaft
book
8. Remove the lower left mounting bolt,
9. Remove the pressure pipe and the return pipe.
IO. Remove the left bracket.
11 I Pull the steering gear from the left side to remove it.
Installation note
Bolt (Steering gear mounting bolt)
Tightening torque:
Pressure pipe (O-ring replace):
29-39 (3-4, 22-29)
Return pipe (O-ring replace):
29-39 (3-4, 22-29)
Propeller shaft (Refer to Section 1):
27-30 (2.8-3.1, 20-22)
Exhaust
pipe (Gasket replace)
A: 31-46 (3.2-4.7, 23-34)
B: 21-27 (2.1-2.8, M-20)
C: 40-55 (4.1-5.6, 30-41)
No.4 engine mount: 67-93 (6.8-9.5, 49-69)
Engine mount member: 64-89 (6.5-9.1, 47-66)
No.1 and No.2 engine mount nut:
37-52 (3.8-5.3, 27-38)
Nwm (m-kg, ft-tb)
N-9