Mazda 1990 323 Workshop Manual Supplement page 167

TRANSAXLE AND TRANSFER UNIT
I
03UOJl - 126
03UOJ3-162
03UOJ3-163
03UOJ3-18
Tie-rod end
1. Install the locknut.
Tightening torque:
42-57 N.m (4.3-5.8 m-kg, 31-42 ft-lb)
2. Secure the locknut with a new cotter pin.
Propeller shaft
1. Align the marks and install the propeller shaft.
(Refer to Section L.)
Control cable
1. Install the bracket.
Tightening torque:
18-25 N#m (1.9-2.8 m-kg, 13-18 ft-lb)
2. Attach the control cable to the bracket with the clip.
3. Connect the control cable to the transaxle and transfer unit
and install the washers and the pins.
4. Connect the ground to the clutch pipe bracket.
Tightening torque:
15-22 N-m (1.6-2.3 m-kg, 11-16 ft-lb)
Neutral switch connector
1. Install the bracket.
2. Connect the neutral switch connector.
J3-89