Mazda 1990 323 Workshop Manual Supplement page 435

TRANSAXLE AND TRANSFER UNIT
K2
TRANSAXLE AND TRANSFER UNIT (ASSEMBLY)
Preparation
SST
For
support of
engine
49 GO17 501
Krt of
49 GO17 5AO)
I
I
49 GO17 503
Hook
(Part of
49 GO17 5AO)
For
support of
engine
49 GO17 502
Support
(Part of
49 GO17 5AO)
For
support of
engine
I ,
03UOK2-255
Precaution
1. If the drive plates or brake band are replaced with new ones, soak the new part in ATF for at least 2 hours
before installation.
2. Before assembly, apply ATF to all seal rings, rotating parts, O-rings, and sliding parts.
3. All O-rings, seals, and gaskets must be replaced with the new ones included in the overhaul kit.
4. Use petroleum jelly, not grease, during reassembly.
5. When it is necessary to replace a bushing, replace the subassembly that includes that bushing.
6. Assemble the housing within 10 minutes after applying sealant, and allow it to cure at least 30 minutes
after assembly before filling the transaxle with ATF.
03UOKX-442
K2-259