Mazda 1990 323 Workshop Manual Supplement page 317

ELECTRONIC SYSTEM COMPONENTS
K2
03UOKX-13;
V
03UOKZ091
03UOK2-095
03UOK2-096
I
03UOK2-097
Inspection of continuity
1. Disconnect the inhibitor switch connector.
2. Check continuity of the terminals.
1 Position Iv
Connector terminal
I I \ClDlEtFlG
IProlol
O----O: Indicates continuity
3. If not correct, replace the switch and perform adjustment
of the inhibitor switch.
4. If correct, check or adjust the selector lever.
Replacement
1. Disconnect the negative battery cable.
2. Remove the air hose and disconnect the harness.
3. Remove the clip.
4. Remove the bolts and the manual shaft nuts.
5. Install the new inhibitor switch and the manual shaft nuts.
Tightening torque:
8-11 N.m (80-110 cm-kg, 69-95 in-lb)
6. Align the holes of the inhibitor switch and the selector lever
by inserting an
approx. 2.0mm (0.079 in)
diameter pin.
7. Connect the harness and install the air hose.
8. Connect the negative battery cable.
9. Inspection of inhibitor switch.
Adjustment
1.
Remove the air hose.
2. Turn the manual shaft to N position.
3. Loosen the inhibitor switch mounting bolts.
4. Align the holes of the inhibitor switch and the manual shaft
lever by inserting an
approx. 2.0mm (0.079 in)
diameter
pin.
5. Tighten the mounting bolts.
Tightening torque:
8-l
1 Nnrn (80-l 10 cm-kg, 69-95 in-lb)
6. Recheck the continuity of the inhibitor switch.
7. If not correct, replace the inhibitor switch.
K2-141