Mazda 1990 323 Workshop Manual Supplement page 372

K2
TRANSAXLE AND TRANSFER UNIT
03UOKX-29
03UOKX-293
03UOK2-18.5
1
Note
0 Installation order:
Driven-Drive-Driven-Drive-Driven-Drive-
Driven-Drive
8. Install the drive and driven plates.
9. Install the retaining plate.
10. Install the snap ring.
11. Measure the low and reverse brake clearance.
(1) Measure the clearance between the snap ring and the
low and reverse brake retaining plate.
(2) If the clearance is not within specification, adjust it by
selecting a proper retaining plate.
Low and reverse brake clearance:
2.1-2.4mm (0.083-0.094 in)
Retaining plate sizes
mm (in)
10.0 (0.3937) 10.2 (0.4016) 10.4 (0.4094)
10.6 (0.4173) 10.8 (0.4252)
12. Check the low and reverse brake operation by applying
compressed air through the fluid passage as shown in the
figure.
Air pressure: 392 kPa (4.0 kg/cm2, 57 psi)
I
03UOKX-295
K2-196