Mazda 1990 323 Workshop Manual Supplement page 545

WHEEL ALIGNMENT
R
03UORX-014
Camber and Caster
Note
l
Caster is not adlustable.
I. Jack up the front of the vehicle and support it with safety
stands.
2, Remove the mounting block nuts.
4. Install and tighten the mounting nuts to the specified torque.
Tightening torque:
29-40
Nmm (3.0-4.1 m-kg, 22-30 ft-lb)
Adjustments
Total toe-in
To adjust the toe-in, loosen the left and right tie-rod locknuts,
then turn the tie-rods equally.
Caution
l
The left and right tie-rods are both right threaded,
so, to increase the toe-in, turn the right tie-rod to-
ward the front of the vehicle and the left tie-rod
equally toward the rear.
l
One turn of the tie-rod (both sides) changes the toe-
in by about 6mm (0.24 in).
Tighten the tie-rod locknuts.
Tightening torque:
34-39
NOm (3.5-4.0 m-kg, 25-29 ft-lb)
Revised 1 t/89
(1990 323 2WD) R-7