Mazda 1990 323 Workshop Manual Supplement page 480

PROPELLER SHAFT
Removal Note
Nuts
1. Before removing the propeller shaft, mark the flanges for
proper reassembly.
03UOLX-808
03UOLX-8f
SPACER
FRONT StDE
I
REAR SIDE
1
7
Spacers
1. Identify the specers for proper reassembly.
Installation Note
Propeller shaft
1. Align the marks and install the propeller shaft,
2. Verify that there is no abnormal noise or vibration when driv-
ing the vehicle.
Note
l
The spacer on each side must be the same size.
3. If noise or vibration seems to be the result of incorrect pro-
peller shaft alignment angle, substitute different spacer at
the center bearing support assembly to eliminate the
problem.
No spacer
4.5 (0.18)
10.0 (0.39)
Spacer size
mm (in)
1.6 (0.06)
6.0 (0.24)
13.0 (0.51)
3.2 (0.13)
8.0 (0.31)
L-6