Mazda 1990 323 Workshop Manual Supplement page 318

ELECTRONIC SYSTEM COMPONENTS
03UOK2-091
03UOK2-099
03UOKX-14i
03UOKX-I 46
8. Connect the selecter lever.
Tightening torque:
44-64 N-m (4.5-6.5 m-kg, 33-47 ft-lb)
ATF THERMOSWITCH
Inspection
1. Remove the ATF thermoswitch.
2. Place the switch in oil with a thermometer as shown, and
heat it up gradually.
3. Check the continuity of the terminals. If necessary replace
the switch.
Connection guide
Fluid temperature Continuity
Above 150 f 3°C (302 f 37'F) 1 Yes
I
Below 143T (289OF) I No
I
PULSE GENERATOR
Inspection
Inspection of resistance
1. Disconnect the pulse generator connector.
2. Measure resistance between the terminals E and F.
Resistance: 200--4OOQ
3.
If not
correct, replace the pulse generator.
Tightening torque:
8-l 1 N-m (80-l 10 cm-kg, 69-95 in-lb)
K2-142