Mazda 1990 323 Workshop Manual Supplement page 498

M
REAR DRIVESHAFT
03UOMX-83t
Disassembly Note
Clip
Caution
l
Mark with paint, do not use a punch. --
1. Mark the outer ring and the cage for proper reassembly.
2. Remove the ciip with a screwdriver.
Snap ring
Caution
l
Mark with paint, do not use a punch.
1 I Mark the axleshaft, the cage and the inner ring for proper
reassembly ,
2. Remove the snap ring with snap-ring ptiers.
Cage
1. Turn the cage approximately 3CP, then puH it away from
the inner ring.
03UOMX-831
-
03UOMX-833
TAPE
I
Inner ring
1. Remove the
a hammer.
inner ring from the driveshaft with a bar and
Boot
Caution
l
Do not remove the boot (wheel side) if not
necessary.
1. Wrap the splines of the driveshaft with tape to prevent
damaging the boot.
2. Remove the boot.
-'
03UOMX-834
M-14