Mazda 1990 323 Workshop Manual Supplement page 434

K2
TRANSAXLE AND TRANSFER UNIT
03UOKX-437
03UOK2-321
\
03UOKX-439
(14) Remove the transaxle case and SST.
(15) Install the required shim(s) and tap the bearing race into
the transaxle case.
(16) Install the transaxle case.
Tightening torque:
37-52 N.m (3.8-5.3 m-kg, 27-38 ft-lb)
(17) Verify that the preload is within specification. If not within
specification, return to Step (1).
Preload: 2.9-3.9 N,rn (30-40 cm-kg, 26-35 in-lb)
(18) Remove the transaxle case.
3. Install the idler gear and output gear as an assembly by
tapping in with a plastic hammer.
4. Install the bearing housing.
(1) Mount the bearing housing onto the converter housing.
Tightening torque:
19-26 N.m (1.9-2.6 m-kg, 14-19 ft-lb)
(2) Align the groove on the idler shaft with the mark on the
bearing housing.
(3) Tap a new roll pin in with a pin punch and hammer.
03UOKX-440
K2-258