J3
TRANSAXLE
AND TRANSFER
UNIT
03UOJ3-21
I
03UOJ3-179
03UOJ3-181
03UOKX-49
Driveshaft
Caution
l
Do not damage the oil seal.
l
After installation,
pull the front hub outward to verify
that the driveshaft
is secured.
-'
1. Replace
the clips at the ends of the driveshafts
and joint
shaft with new ones.
2. Push the driveshafts
into the differential
with the groove
of
the clips upward.
Note
l
Apply ATF to the oil seal lip.
3. Install the driveshaft.
4. Tighten
the joint shaft mounting
bolts in the order shown.
Tightening
torque:
42-62
N*m (4.3-6.3
m-kg, 31-46
ft-lb)
5. Install the lower arm ball joint to the knuckle
and tighten
the
bolt.
Tightening
torque:
43-54
N-m (4.4-6.0
m-kg, 32-40
ft-lb)
Stabilizer
1. Tighten
the stabilizer
nut so that
17mm (0.67 in)
to
19mm
(0.75
in)
of thread
is exposed
at the end of the bolt.
'-I