Mazda 1990 323 Workshop Manual Supplement page 44

IJ
INSTALLATION
r
03UOBX-831
0311082-832
,
93EOB2-061
93EOB2-07t
Propeller shaft
1. Install the propeller shaft. (Refer to page L-5.)
Driveshaft
1. Apply grease to the end of the driveshaft.
Caution
l
When installing the driveshaft, be careful not to
damage the oil seal.
l
After installation, pull the front hub outward to con-
firm that the driveshaft is securely held by the clip.
2. Install the driveshaft and a new clip.
3. Install the lower arm ball joint to the knuckle and tighten the
clinch bolt.
Tightening torque:
43-59 N*m (4.4-6.0 m-kg, 31-43 ft-lb)
4. Install the joint shaft.
5. Tighten the bolts in the order shown.
Tightening torque:
42-62 N*m (4.3-6.3 m-kg, 31-46 ft-lb)
Tie-rod end
1. Install the tie-rod end to the knuckle.
Tightening torque:
42-57 N-m (4.3-5.6 m-kg, 31-42 ft-lb)
2. Install a new cotter pin.
Stabilizer
1. Install and adjust the stabilizer.
Dimension A: 17-19mm (0.67-0.75 in)
Tightening torque:
16-23 N-m (1.6-2.3 m-kg, 12-17 ft-lb)