Mazda 1990 323 Workshop Manual Supplement page 430

K2
TRANSAXLE AND TRANSFER UNIT
03UOKX-42.
76G07EL72:
. I
03UOKX-42!
03UOKX-426
03UOKX-42'
K2-254
Caution
l
Eliminate the gap (arrow) by turning A or B of the
selector.
(5) Install the outer race removed in Step (3) to the SST.
Set the SST and outer race onto the output gear as-
sem bly.
--
(6) Set the four SST on the converter housing in the posi-
tions shown.
(7) Set the bearing housing on the SST (selector) and in-
stall the four SST (bolts); then tighten them to the speci-
fied torque.
Tightening torque:
19-26 N.m (1.9-2.6 m-kg, 14-16 ft-lb)
Note
l
Seat the bearing.
(8) Turn the SST (selector) to increase the clearance indi-
cated by the arrow with the SST (bars) until it no longer
turns.
(9) Turn the selector in the opposite direction until the gap
is reduced.
(10) Mount the SST and pull scale or torque wrench on the
output gear.
(11) Adjust the clearance between A and B to obtain the
specified preloadlpull scale reading.
Preload:
0.03-0.9 N.m (0.3-9.0 cm-kg, 0.26-7.61 in-lb)
Reading on pull scale:
0.3-9 N (0.03-0.9 kg, 0.066-1.96 lb)
-,