Rear Axle; Disc Brake Type =.=I - Mazda 1990 323 Workshop Manual Supplement

REAR AXLE
M
DISC BRAKE TYPE
Preinspection
Wheel bearing play
1. Remove the wheel and tire.
2. Remove the brake caliper assembly.
3. Position a dial indicator against the wheel hub. Push and
pull the wheel hub by hand in the axial direction and meas-
ure the wheel bearing play.
4. If the bearing play exceeds specification, check and adjust
the wheel hub nut torque or replace the wheel bearing if
necessary.
Maximum wheel bearing play: 0.05mm (0.002 in)
Removal I Inspection I Installation
1. Remove in the order shown in the figure, referring to Removal Note.
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal, referring to Installation Note.
N-m (m-kg, R-lb
1~ Wheel and tire
2. Wheel hub nut
Installation
Note . . . . . . . . . . . . . . . . . . . . . . ..I.. page M-8
3. Brake caliper assembly
Service ,,.....,....,~,,..,..,..............I.....
Section P
4. Disc ptate
Service ,..,.,..,. e ,............. 1 ,... m .,..,.....,
Section
P
5. Trailing link
6. Lateral link
7. Shock absorber
8. Wheel hub, knuckle
Disassembly I Inspection I
Assembly . . . . . . . . . . . . . . -. . , . , . . , . %,. . . . . , . . .
page
M-8
M-7