Mazda 1990 323 Workshop Manual Supplement page 201

TROUBLESHOOTING GUIDE
K2
Troubleshooting chart
1 VEHICLE DOES NOT MOVE IN D, S, L, AND R RANGES
DESCRIP- *Vehicle does not move when accelerator depressed, engine speed increases
TION
[TROUBLESHOOTING HINTS]
@ ATF level low
@ Oil pump worn
@ Selector lever installation or adjustment incorrect
@ Torque converter worn
@ Powertrain slippage (Forward clutch, one-way clutch 1,
@ Hydraulic circuit clogged or leakrng (Forward clutch. re-
one-way clutch 2, low and reverse brake or reverse
verse clutch or low and reverse brake)
clutch) @ Parking mechanism malfunction
@ Control valve stuck (Manual valve or pressure regulator
valve)
STEP INSPECTION
ACTION
1
Check if ATF level is OK Yes Go to next step
w page K2-134
Level:
Between notches on HOT side of level
gauge at 65% (149°F)
Add ATF to specified level
OSJOFX-021
DESCRIPTION:
Further describes the symptom. Confirm that the chart addresses the actual symptom before beginning
troubleshooting.
TROUBLESHOOTING HINTS:
This describes the possible point of malfunction.
STEP:
This shows the order of troubleshooting. Proceed with troubleshooting as indicated.
INSPECTION:
This describes an inspection to quickly determine the malfunction of parts. If a detailed procedure is necessary
to perform the INSPECTION, refer to the page shown by the "a" mark.
ACTION:
This recommends the appropriate action to take as a result (Yes/No) of the INSPECTION. How to perform
the action is described on the reference page shown by the 'W mark.
03l J OKX-022
K2-25