Mazda 1990 323 Workshop Manual Supplement page 447

TRANSAXLE AND TRANSFER UNIT
K2
CLEARANCE(A)
I
03UOK2-280
(5) Measure clearance A between the transaxle case and
the oil pump.
(6) Select a suitable bearing race from the chart below.
Clearance A mm (in)
Select this bearing race
mm (in)
0.91-1.10
(0.036-0.043)
1.2 (0.047)
0.71-0.90 (0.028-0.035)
1.4 (0.055)
0.51-0.70 (0.020-0.027)
1.6 (0.063)
0.31-0.50 (0.012-0.019)
1.8 (0.071)
0.11-0.30 (0.004-0.011)
2.0
(0.078)
o-0.10 (O-0.003) 2.2 (0.087)
(7) Remove the oil pump.
(8) Place the selected bearing race and a new gasket onto
the oil pump.
(9) Install the oil pump onto the clutch assembly.
Tightening torque:
19-26 N,m (I .9-2.6 m-kg, 14-19 ft-lb)
32. Adjust the 2-4 brake band.
(1) Loosen the locknut and tighten the piston stem to the
specified torque.
Tightening torque:
9-I I N.m (90-l IO cm-kg, 78-95 in-lb)
(2) Loosen the piston stem 2 turns.
(3) Hold the piston stem and tighten the locknut to the speci-
fied torque.
Tightening torque:
25-39 N*m (2.5-4.0 m-kg, 18-29 ft-lb)
33. Install the oil strainer along with a new O-ring to the transaxle.
Tightening torque:
8-I I N-m (80-l IO cm-kg, 69-95 in-lb)
I
03UOK2-281
K2-271