Mazda 1990 323 Workshop Manual Supplement page 453

TRANSAXLE AND TRANSFER UNIT
K2
1. Transaxle and transfer
Installation Note . . . . . . . . . . . . . . . . . . . . . . page K2-277
2.
Oil hose (Outlet side)
Installation
Note . . . . . . . . . . . . . . . . . . . . . . page K2-277
3.
Oil hose (Inlet side)
Installation Note . . . . . . . . . . . . . . . . . . . . . . page K2-277
4. Engine mount No.2
5. Engine mounting member
Installation Note.. . . . . . . . . . . . . . . . . . . . page K2-278
6. Starter
7. Center differential lock motor
8. Driveshaft
Installation Note . . . . . . . . . . . . . . . . . . . . page K2-278
9. Joint shaft
10. Stabilizer
Installation
Note . . . . . . . . . . . . . . . . . . . . . . page K2-279
11. Tie-rod end
12. Exhaust pipe
03UOK2-300
I
I
I ,
03UOK2-301
I
13. Cross member
14. Integrated stiffener
15. Propeller shaft
Installation
Note . . . . . . . . . . . . . . . . . . . . . . page K2-279
16. Under cover
17. Differential lock sensor switch connector
18. Differential lock motor connector
19. Solenoid valve connector
20. Inhibitor switch connector
21. Speedometer cable
Installation Note . . . . . . . . . . . . . . . . . . . . . . page K2-279
22. Battery carrier
23. Battery
24. Air hose and air cleaner assembly
25.
Splash shield
26. Wheel and tire
27. Throttle cable
Installation
Note . . . . . . . . . . . . . . . . . . . . . . page KZ-279
03UOK2-299
Installation Note
Transaxle and transfer
Caution
l
Do not lean the transaxle and transfer to torque con-
verter side.
1, Use an engine hoist, and install the transaxle and transfer.
2. Mount the transaxle and transfer to the engine.
3. Install the bolt.
Tightening torque:
55-80 N-m (5.6-8.2 m-kg, 41-59 ft-lb)
Oil hose (inlet and outlet side)
1. Align the marks, and slide the oil cooler hose onto the oil
cooler pipe untrl It is fully seated against the ridge.
2. Install the hose clamp onto the hose at the center of the
mark and at the angle shown.
3. Verify that the hose clamp does not interfere with any other
parts.
I
/
DOWN
SIDE
I
I
03UOKX-497
K2-277