2: Installation And Setup; Site Requirements; Physical Operating Environment; External Exhaust Ducting - Christie Solaria CP2220 User Manual

2 Installation and Setup
This section explains how to install, connect and optimize the projector for delivery of superior image quality.
NOTE: Illustrations are graphical representations only and are provided to enhance the understanding of the
written material.
2.1

Site Requirements

The following site requirements are required for safe installation and operation of the CP2220:

Physical Operating Environment

• Maximum Ambient Temperature (operating)
• Minimum Ambient Temperature (operating)

External Exhaust Ducting

• The installation site must provide a minimum of 450 CFM (ft
quate cooling of the projector's Xenon arc lamp at less than or equal to 25°C ambient and less than 3,000 feet
elevation. Above 25°C or 3,000 feet, 600 CFM is required. For detailed instructions on how to measure CFM
refer to STEP 5 - Connect External Exhaust Ducting, on page 2-5.

Permanent Power Connection

• A 30-32A double pole, UL listed wall circuit breaker is required. It must be part of the building installation
and easily accessible.
• Single-phase 30A connection of AC supply to the terminal block.
• Protection from overcurrents, short circuits and earth faults must be part of the building installation. The dis-
connect device (double pole switch or circuit breaker with minimum 3mm contact gap) must be readily
accessible within the projection room.
Refer to STEP 8 - Connect Power, on page 2-8
2.2

Tools Required for Installation

Before you begin installation, it is important to fully understand all site requirements and characteristics, and
that you have the following tools and components on hand.
12" screwdrivers: Phillips #2 (magnetic) and flat
19mm and 7/8" wrenches
Assorted Allen keys (metric)
Heat extractor
Protective clothing/safety gear (required when handling the lamp)
Lamp
Lens cleaning tissue and solution
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
35°C
10°C
3
/min) external exhaust airflow to ensure ade-
for detailed instructions.
2-1