Christie Solaria CP2220 User Manual page 32

Section 2: Installation and Setup
STEP 9 - Connect Sources and Initial Power Up
Once the lamp is installed, the projector is essentially ready for operation. Although an image is not required at
this time, it is recommended that external cinema servers and sources be connected.
Before igniting the lamp for the first time, it is essential the following steps be completed to ensure successful
communication.
1. Assign the projector a unique IP address. Each projector is given a default IP address, however if you
are connecting the projector to an existing network you must give it a new IP address. For first time
installations, assign the IP address in Administrator Setup: Communications Configuration window
using the Touch Panel Controller.
2. Set the baud rate. Set the baud rate to match the external device connected (such as a server). The
projector's default baud rate is 9600 Kbps.
3. Enter Lamp information. From the Advanced Setup: Lamp History window define the type of lamp
installed, serial number and the number of hours currently logged on the lamp (if any).
4. Power-up the projector.
5. Perform LampLOC™ alignment immediately on the newly installed lamp. This will ensure the lamp
is positioned correctly to achieve maximum light output. Access LampLOC™ features in Advanced
Setup: LampLOC™ Setup window.
6. Perform initial optical alignment in order to optimize images displayed on screen. These adjustments
must be done before boresight adjustments. Refer to
7. Adjust optical components when needed. In rare instances, the installer may have to adjust one or more
optical components.
2-12
2.8 Basic Image Alignment, on page 2-17.
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)