Liquid Cooling Air Filter Replacement; Lens Replacement - Christie Solaria CP2220 User Manual

Liquid Cooling Air Filter Replacement

CHECK: Monthly
The radiator air filter is located on left/front side of the projector behind a small air filter cover.
1. Release a single tab on the air filter cover and remove.
2. Slide the air filter out and discard. Insert the new air filter with the air flow indicator facing toward the
projector. NOTE: Never reuse an old air filter. The air filters in this product cannot be cleaned thoroughly
enough for reuse and can lead to the contamination of optical components.
3. Install the air filter cover by inserting the bottom tabs into place and then snapping the door closed.
4.5

Lens Replacement

A variety of primary lenses can accommodate different throw distances and specific types of installations.
These are listed in
To replace a lens in the projector, do the following:
1. Turn the lens clamp to the OPEN/UP position.
2. Release the lens locking lever (UP position).
3. Pull out the lens and replace it with a different high-brightness lens. NOTE: Always install the lens with
"UP" label in the top position. This will assist in achieving consistent boresight alignment each time the
lens is replaced. Refer to
4. Secure the lens with the lens locking lever (DOWN position).
5. Calibrate the lens.
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
Section 6 Specifications.
STEP 6 - Install Lens, on page 2-6.
Section 4: Maintenance
4-11