Projector Led Status Indicators - Christie Solaria CP2220 User Manual

3.5.3 Projector LED Status Indicators

In addition to the status indicators on the TPC, there are 2 sets of color-coded LED status indicators affixed to
the top, rear corner of the projector skins - one set per side. These LEDs are designed to be easily viewable
from a distance and on a wide angle so that the status of multiple projectors in a multiplex can be determined
with a quick glance. The LEDs are ordered from top to bottom as red, yellow, and green. To communicate
more information, the LEDs can be solid, flash or blip. Flashing is a regular ON/OFF cycle of the LED, while
blipping has a long ON time with a brief OFF time. A blipping LED should appear to be solid, with periodic
hiccups. Each LED has a specific meaning that quickly communicates the state of the projector.
Table 3.6 Projector Status LED Legend
LED
Solid Green
Green Blip
Solid Yellow
Yellow Blip/
Green Blip
Flashing Red
Solid Red
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
State
Lamp ON
Power ON
Standby mode
Cool down mode
New critical alarm or warning
Existing critical alarm or warning
Description
Power is ON, Lamp is ON.
Power is ON, Lamp is OFF. The lamp can be struck when in
this mode.
Power is OFF, Lamp is OFF. Power saving mode.
Transitioning to STANDBY mode.
Power is ON, Lamp is OFF.
The lamp can be struck when in this mode.
New critical alarm or warning has NOT been acknowledged
by operator.
Critical alarm or warning exists, but has been acknowledged
by operator.
Section 3: Operation
3-15