Advanced Setup: Ils File Setup Window - Christie Solaria CP2220 User Manual

Section 3: Operation
Region
3: Auto
LampLOC™

Advanced Setup: ILS File Setup Window

WARNING
the MALM to the OUT position before performing any lens calibrate or reset functions on the
Motorized Primary Lens Mount to prevent collision between the projection lens and the
MALM. 2) Hazardous moving parts. Keep fingers and other body parts away.
The optional Intelligent Lens System (ILS) automates the process of adjusting the Focus, Horizontal (X) and
Vertical (Y) Offset, and Zoom of the lens using a motorized lens mount. When installed and enabled (ILS
Installed check box and Enable Automatic ILS check box in the Advanced Setup: Lens Setup window
are selected), this window is used to modify the Intelligent Lens System (ILS) settings of ILS files. Any
adjustments made to an ILS file will affect every channel that uses the file. You can adjust the focus, offset, or
zoom using short, quick presses to advance the motors only a small step, slightly longer presses to advance
more steps at a time, or hold the button for an accelerated movement. Experiment to get the feel. Reversing
direction will cause a normal and deliberate overshoot and correction to take out any play in the precision
mechanism for more precise results. Position values on the window will change in real-time. For more
information, refer to
available if the ILS Installed check box on the Advanced Setup: Lens Setup window is not selected. 2) If the
Enable Automatic ILS check box on the Advanced Setup: Lens Setup window is not selected, a warning will
display when trying to access the ILS File Setup window. Upon acknowledging the message, the options in the
ILS File Setup window will be disabled (greyed). 3) Using the knobs on the lens mount to adjust these positions
does not save the settings to the ILS file. Adjustments made using the knobs will be lost once ILS becomes
enabled again. 4) Avoid long hair, jewelry, and loose clothing exposure to the knobs during manual
adjustment. 5) In case of emergency, unplug the line cord to immediately halt movement of the lens mount.
3-34
Control Description
Do Auto
Starts the auto LampLOC™ calibration procedure, which adjusts the lamp posi-
tion until the highest light reading is obtained from the light sensor. Displays the
LampLOC™ progress bar and Cancel Auto button.
Display Full
Select to temporarily display a full screen white test pattern for the duration of the
LampLOC™ adjustment. The previous display resumes when the LampLOC™
Screen
procedure is complete or the check box is cleared. Although it is not necessary to
White
display a white test screen, it is often useful to visually monitor the motor action
Test Pattern
to assure the system is optimizing properly.
Shows the current LampLOC™ procedure completion status when the Do Auto
Auto
button is clicked. When status is finished, this bar and the Cancel Auto button
LampLOC™
become hidden again.
Progress
Bar
Cancel Auto When the Cancel Auto button is clicked, the current LampLOC™ procedure is
cancelled. The progress bar and Cancel Auto button will become hidden again.
1) If the Motorized Auxiliary Lens Mount (MALM) is present, ensure to move
Appendix A: Intelligent Lens
System. NOTES: 1) The ILS File Setup menu is not
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)