Lens Mount Functions - Christie Solaria CP2220 User Manual

A.1.1 Lens Mount Functions
WARNING
before performing any lens calibrate or reset functions on the Motorized Primary Lens Mount to prevent
collision between the projection lens and the MALM. 2) Hazardous moving parts. Keep fingers and
other body parts away. Remotely operated motors may start to spin without warning. Keep clear of
rotating parts and avoid long hair, jewelry, and loose clothing exposure to the knobs during manual
adjustment.
NOTES: 1) In case of emergency, unplug the interface cable at the top left corner above the lens mount to
immediately halt movement of the lens mount. 2) Only Advanced users can modify channel settings. 2) The ILS
Installed check box in the Advanced Setup: Lens Setup window must be selected for all ILS adjustments.
Access the ILS
• From the Main panel, click the
• From the Advanced Setup window, select the ILS File Setup window.
Enable ILS Per Channel
The ILS adjusts each motor for the Zoom, Offset, and Focus based on the ILS settings of the selected channel
when ILS is enabled.
1. From the Main panel, select one of the available channels.
2. Click the
Test Patterns
3. Click the
Lens Adjust
4. Select the
Enable Automatic ILS
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
1) If present, move the Motorized Auxiliary Lens Mount (MALM) to the OUT position
Figure A-2 Intelligent Lens System
Lens Adjust
button from the Main panel and select a test pattern.
button from the Main panel to launch the ILS Adjust window.
check box to automatically apply the active channel settings.
button.
Appendix A: Intelligent Lens System
A-3