Adjusting Lamp Position (Lamploc™) - Christie Solaria CP2220 User Manual

11. Once the lamp change is complete click Finish from the screen shown in Figure 3-64.
3.6.3 Adjusting Lamp Position (LampLOC™)
To ensure optimal lamp performance and peak brightness at the screen for the life of the lamp, activate
LampLOC™ by clicking the Do Auto button in the Advanced Setup: LampLOC™ Setup window to adjust
the lamp position whenever a new lamp is installed in the projector. Once LampLOC™ adjustment is
complete, the lamp will be well-centered and distanced correctly from the remainder of the illumination
system. NOTE: You can adjust lamp position either before or after adjustment of Lamp Power % or
LiteLOC™.
Before adjusting LampLOC™, ensure the following criteria are met:
• The lamp is installed with the anode yoke in the correct location for the lamp type. Refer to Figure 2-9.
• The correct use of the lamp extension nut with CDXL-30SD lamps is met. NOTE: The projector is shipped
with a lamp extension nut fastened to the cathode end of the lamp holder. Use this nut with CDXL-30SD
lamps only. This will ensure proper placement of this lamp type. If you are installing any other lamp type,
remove this nut and retain it for future lamp replacements by threading it into the dedicated stud in the base-
plate. Leaving the extension nut on with the wrong lamp type can lead to extremely dim light output.
• The lamp must be ON and the douser (shutter) OPEN during adjustment. A 10-minute warm-up is recom-
mended. Ensure to follow all the criteria specified in
• Perform a white test pattern. This is recommended to allow you to view LampLOC™ progress on-screen.
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
Figure 3-64 Lamp Change Completed
3.1.1 Powering Up the Projector, on page
Section 3: Operation
3-1.
3-79