Advanced Setup: Screen File Setup Window - Christie Solaria CP2220 User Manual

Section 3: Operation

Advanced Setup: Screen File Setup Window

The Advanced: Screen File Setup window defines the portion of the projector's display panel you wish to use and any
cropping that is needed to disguise possible keystoning or other geometric aberrations. Once saved, a screen file can be
used with any incoming source as desired. The default source files are called Flat and Scope, which must be defined
before you can select them in the Channel Setup: Config 1 window. Screen data is not included in a PCF and is
independent of source settings. Consider screen files as convenient compensations for physical limitations in the
environment. You will typically need one or two screen files per site.
Table 3.24 Advanced Setup: Screen File Setup Window
Control
Letter Box
Lens Factor
Presentation
3-40
Figure 3-28 Advanced Setup: Screen File Setup Window
Description
Select the Letter Box check box to ensure that all image data is displayed and its aspect ratio is
maintained. See Letter Box Notes below.
Define the anamorphic lens needed to stretch an image horizontally. In the Lens Factor list, click
the Launch Dialog button to enter the new lens factor where values can range from 0.00 to 7.99.
Leave at 1 (default) if no anamorphic lens is needed.
Define the projector's display area to incoming data, i.e. the display size and location. By default,
the projector uses its complete display area (a full 2048 x 1080 panel). See Presentation Notes
below. To adjust the top, left presentation point, select the top left option button and then adjust
the X/Y values using one of the two options:
• adjust the sliders to increase/decrease the value. Using the sliders moves the projected display
area in real-time.
• click the Launch Dialog button in the Presentation X/Y lists to enter a value using the on-
screen keyboard.
Repeat this action after clicking the bottom right option button.
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)