Christie Solaria CP2220 User Manual page 149

STEP 7: Re-install the Front Lamp Duct
Critical! As you install the front lamp duct, lift the small light
shield on the rear lamp duct cover so that it does not get jammed
between the two pieces when they come together. (Figure 4-3)
To ensure a good fit between the two pieces, squeeze the top
and bottom cover snaps to ensure they are locked in place. The
light shield should move freely to the touch.
STEP 8: Close Lamp Door
STEP 9: Turn Wall Circuit ON
STEP 10: Software Adjustments
In the Advanced Setup: Lamp History window, click the
Add Lamp button and record lamp type, serial number, rea-
son for change and number of the hours logged on to the
lamp. If the lamp has not been previously used, enter 0.
Click Save to save the data entered(Figure 4-4).
NOTE: This step can also be performed through the Lamp
Wizard. For details, refer to 3.6.2 Using the Lamp Change
Wizard, on page 3-77.
STEP 11: Turn Lamp ON
Click
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
Figure 4-2 Install New Lamp
=from the TPC Main panel to turn the lamp on.
Section 4: Maintenance
Figure 4-3 Light Shield on Front
Lamp Duct
Figure 4-4 Add Lamp Window
4-9