Section 2: Installation and Setup
2.10.2 Fold Mirror Adjustment
If a corner or edge of the image is missing (after prime lens offset is ruled out), this may indicate the fold
mirror has become misaligned with the rest of the optical system, resulting in cropping of data. To correct this
issue, use the two adjustment screws that are accessible through the base of the projector. See Figure 2-26.
• To raise or lower the image, adjust the screw closest to the operator's side (right side, when facing screen).
• To move the image left or right, adjust the screw on the left side.
2-22
Base of projector
FRONT
3mm
hex
driver
image
image
Figure 2-26 Fold Mirror Adjustment
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)