Christie Solaria CP2220 User Manual page 24

Section 2: Installation and Setup
NOTES: 1) For best optical performance, avoid tilting the projector
excessively. Use vertical offset of the lens instead. 2) The front-to-back tilt of
the projector must not exceed 15°. This limit ensures safe lamp operation
and proper position of the liquid cooling reservoir in the projector.
Adjusting Feet/Leveling
To adjust the height or level of the projector, extend or retract the adjustable
feet located on the bottom of the projector by rotating them. Once the
required adjustment is made, tighten the lock nut. See Figure 2-2.
WARNING! Make sure the projector's rear safety strap is in
place before adjusting the projector's feet.
STEP 4 - Mount Touch Panel Controller (TPC)
The TPC comes pre-assembled with its base and mounting arm. It is shipped separately and must be mounted
to the projector during installation.
When installing the TPC:
1. Loosen the mounting arm just enough for the end to fit over the ball joint located on the rear panel of the
projector. Figure 2-3
2. Tighten the mounting arm until it fits snug on the ball joint. Figure 2-4
3. Connect the cable from the TPC to the connector located on the projector's rear panel.
4. Adjust the angle of the TPC as desired.
2-4
Figure 2-3
Figure 2-4
Figure 2-2 Adjust Feet
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)