Christie Solaria CP2220 User Manual page 209

Appendix E: 3D Connector
The 3D connector is a 15-pin D-sub connector (female) located on the PIB Board. The following table lists the
control functions available through the 3D connector.
PIN SIGNAL NAME
1 +12V
2 GND
3 GND
4 RS232_RX
5 RS232_TX
6 CONN_3D_MODE+
7 CONN_SYNC+
8 3D_INPUT_REFRERENCE+
9 +12V
10 3D_INPUT_REFRERENCE-
11 3D_DISPLAY_REFERENCE+
12 3D_DISPLAY_REFERENCE-
13 CONN_3D_MODE-
14 CONN_SYNC-
15 Not connected
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
DIRECTION DESCRIPTION
Out Power to 3D device. Maximum 1A (total between both
+12V pins).
/ Ground
/ Ground
In Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
Out Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
In 3D L/R Input Reference (P)
(Voltage Limit: 1.4VDC to 12VDC)
Out Power to 3D system. Maximum 1A (Total between both
+12V pins)
In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
Out 3D mode state from projector. From projector GPO
emitter. Compatible with current projector GPIO
requirements and restrictions. (24VDC max, 50mA
max)
Out SYNC from projector. From projector GPO emitter.
Compatible with current projector GPIO requirements
and restrictions. (24DC max, 50mA max)
E-1