Christie Solaria CP2220 User Manual page 178

Appendix A: Intelligent Lens System
b. If the top edge of the image fails to come into focus
then the image focuses behind the screen.To correct
this problem, adjust the Vertical Boresight Bolt to
direct or aim the lens mount DOWN towards the bot-
tom of the screen.
5. When both sides appear equally blurry, adjust the Offset
by clicking the
Adjust window to re-center the image on the screen.
6. Repeat Steps 2 - 5 until the top and bottom of the screen
are both well-focused.
7. Refocus: Although all sides of the image should now be
in focus, the center of the image may be slightly blurry at
this point. Re-focus the center of the image. The goal is for good focus at the center and on all sides.
8. Adjust the Vertical Locking Screw to lock the lens mount in place and check boresight again (Figure A-
6).
For more information on the TPC ILS File Setup options, refer to
page 3-34.
The ILS can also be adjusted using serial commands. See
these commands.
A-8
buttons on the ILS
up/down/left/right
Figure A-7 Adjust Vertical Boresight
Advanced Setup: ILS File Setup Window, on
Appendix B: Serial API
Focus Left
Edge Center
for the more information on
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)