Test Patterns - Christie Solaria CP2220 User Manual

Section 3: Operation
All settings on the ILS Adjust window are in real-time. ILS settings are saved in a file called ILS Flat, ILS
Scope, or a user-defined file where each channel specifies the ILS file to use. For more information on channel
settings, refer to
Enable Automatic ILS Selected
When the Enable Automatic ILS check box is selected, the lens automatically moves to the position
indicated in the ILS file associated with the current channel. Changing channels will change the position of the
lens, assuming the new channel uses a different ILS file. When the Enable Automatic ILS check box is
selected, any changes made to the focus, offset and zoom will overwrite the current values in the ILS file,
therefore these changes will affect every channel that uses this ILS file.
Enable Automatic ILS NOT Selected
When the Enable Automatic ILS check box is NOT selected, the lens does not move unless you make
adjustments to the focus, offset and zoom in the Lens Adjust window. These settings will NOT overwrite the
ILS values and changing channels will not affect the position of the lens.
For more information, refer to

Test Patterns

Test patterns are used when setting up a projector to ensure proper image positioning and light on the screen.
The Test Patterns button launches a collection of test patterns predefined in the Administrator Setup:
Preferred Test Pattern Setup window, along with other options to turn the test pattern off, display all test
patterns, and show the projected image on the full screen (this ignores the screen file settings). See Figure 3-3.
For more information, refer to
3-6
Channel Setup: Config 1 Window, on page
Appendix A: Intelligent Lens System.
Administrator Setup: Preferred Test Pattern Setup Window, on page 3-47.
Figure 3-3 Quick Launch Preferred Test Pattern Setup
3-22.
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)