Diagnostics: Smpte Errors Window - Christie Solaria CP2220 User Manual

To Run Interrogator
1. Click an Interrogator mode and then click the Yes button to start the Interrogator process. A progress bar
will display until Interrogator is finished. Once started, the Interrogator cannot be stopped. During this
time, you cannot modify the projector settings. WARNING! Never run Interrogator during a show
as this could cause image disruption. NOTES: 1) For Interrogator to successfully retrieve these
diagnostic files, the projector must remain in its "failed" state (with an incorrectly displayed image on-
screen). 2) Always run Interrogator first before power cycling the projector otherwise important
diagnostic files will be unusable.
2. Once complete, download these files to a USB drive. Open the back flap of the TPC to gain access to the
USB ports. Insert the USB drive and click the Download to USB button.

Diagnostics: SMPTE Errors Window

The Diagnostics: SMPTE Errors window shows the number of SMPTE Errors reported. The SMPTE error
count is a numerical representation of signal integrity on the HD-SDI inputs reaching the projector on the BNC
signal cables. A long or poor quality connection can cause higher counts and may be detectable before
sparkles, or image artifacts are visible. These errors can be cleared, which will also clear the error count and
free up memory for future logs.
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
Figure 3-9 Diagnostics: SMPTE Errors Window
Section 3: Operation
3-17