Lens Mount Components; Projection Lens; Lens Mount - Christie CineLife+ CP4415-RGB Service Manual

Lens mount

components
The lens mount provides a means of securing a projection lens to the projector. Components include
the lens boot, lens mount barrel, and the lens mount offset.

Projection lens

Use the correct method of removing the lens.
1. For motorized lens mounts, disconnect the lens zoom motor from the two zoom motor harness
connectors.
2. Turn the clamp on the lens mount to unlock the projection lens.
3. Slide the lens straight out of the projector.
If the lens does not slide out easily, reset the lens offset. Lock the lens before performing reset
so that it does not fall out.
4. Attach the lens cap to avoid damage to the lens.
5. To re-install, follow these steps in reverse order.
Lens mount
The lens mount, located at the front of the projector, is an assembly of mechanical and electrical
components that securely holds and positions the projection lens.
1. Remove the projection lens (on page 51).
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
51