Calibrating The Lens Mount; Built In Keypad; Projector On, But No Backlight On Built-In Keypad; Image Displays - Christie Roadie HD+35K Setup Manual

4.3

Calibrating the Lens Mount

The lens mount must be calibrated when:
• a new lens has been installed
• the lens mount has been replaced
• lens settings are drifting within a short period of time
4.4

Built In Keypad

4.4.1 Projector ON, but No Backlight on Built-In Keypad

Check the following:
• Confirm the harness is plugged into the back of the built-in keypad (accessible via the lamp compartment
door).
• Touch any key. The backlight for the displays and keys should be present.
4.5

Image Displays

The following troubleshooting entries assume the use of a third-party input source. Before proceeding, consult
the documentation supplied with the external equipment.

4.5.1 Blank Screen, No Display of Image

Check the following:
• Confirm all connections are OK.
• Ensure the lens cap is not on the lens.
• Ensure the shutter is OPEN. Press S
• Ensure a full black test pattern

4.5.2 Severe Motion Artifacts

Most likely there is a synchronization problem with reversed 3-2 drop-down in 60Hz-to-24Hz film-to-digital
conversion in your source. The display file needs correction.
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)
Lens calibration must be performed each time a new lens is inserted or after
performing manual lens mount adjustments. To calibrate the lens, select the
Configuration > Diagnostics and Calibration > ILS Calibration > Reference
Calibration option from the Main menu. This is critical to the projector functioning
properly. Failure to do so could result in damage to the lens mount, the projector, or
the projection lens.
HUTTER OPEN
selected for display.
IS NOT
on the standard IR remote or built-in keypad to open.
Section 4: Troubleshooting
4-3