Specifying Static Interfaces For A Multicast Router - Edge-Core ECS3510-28T Management Manual

| Multicast Filtering
C 17
HAPTER
Layer 2 IGMP (Snooping and Query for IPv4)
S S
PECIFYING TATIC
I
NTERFACES FOR A
M R
ULTICAST OUTER
Figure 355: Configuring General Settings for IGMP Snooping
Use the Multicast > IGMP Snooping > Multicast Router (Add) page to
statically attach an interface to a multicast router/switch.
Depending on network connections, IGMP snooping may not always be able
to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on the switch, the interface (and a specified VLAN) can be manually
configured to join all the current multicast groups supported by the
attached router. This can ensure that multicast traffic is passed to all the
appropriate interfaces within the switch.
CLI R
EFERENCES
◆ "Static Multicast Routing" on page 1214
C U
OMMAND SAGE
IGMP Snooping must be enabled globally on the switch (see
IGMP Snooping and Query Parameters" on page
router port can take effect.
P
ARAMETERS
These parameters are displayed:
VLAN – Selects the VLAN which is to propagate all multicast traffic
◆
coming from the attached multicast router. (Range: 1-4094)
◆ Interface – Activates the Port or Trunk scroll down list.
Port or Trunk – Specifies the interface attached to a multicast router.
◆
– 612 –
"Configuring
608) before a multicast