Configuring The Ipv6 Default Gateway; Configuring Ipv6 Interface Settings - Edge-Core ECS3510-28T Management Manual

C
ONFIGURING THE
IP 6 D
V EFAULT
G
ATEWAY
C IP 6
ONFIGURING V
I S
NTERFACE ETTINGS
Use the IP > IPv6 Configuration (Configure Global) page to configure an
IPv6 default gateway for the switch.
CLI R
EFERENCES
"ipv6 default-gateway" on page 1398
◆
P
ARAMETERS
These parameters are displayed:
Default Gateway – Sets the IPv6 address of the default next hop
◆
router.
An IPv6 default gateway must be defined if the management station
■
is located in a different IPv6 segment.
An IPv6 default gateway can only be successfully set when a
■
network interface that directly connects to the gateway has been
configured on the switch.
W I
EB NTERFACE
To configure an IPv6 default gateway for the switch:
Click IP, IPv6 Configuration.
1.
Select Configure Global from the Action list.
2.
Enter the IPv6 default gateway.
3.
Click Apply.
4.
Figure 330: Configuring the IPv6 Default Gateway
Use the IP > IPv6 Configuration (Configure Interface - VLAN) page to
configure general IPv6 settings for the selected VLAN, including auto-
configuration of a global unicast interface address, explicit configuration of
a link local interface address, the MTU size, and neighbor discovery
protocol settings for duplicate address detection and the neighbor
solicitation interval.
CLI R
EFERENCES
"IPv6 Interface" on page 1397
◆
◆ "DHCP Client" on page 1375
– 569 –
C 15
HAPTER
Setting the Switch's IP Address (IP Version 6)
| IP Configuration