General Snmp Commands; Snmp-Server; Snmp-Server Community - Edge-Core ECS3510-28T Management Manual

General SNMP Commands

snmp-server

snmp-server
community
Table 63: SNMP Commands (Continued)
Command Function
Additional Trap Commands
memory Sets the rising and falling threshold for the memory
utilization alarm
process cpu Sets the rising and falling threshold for the CPU
utilization alarm
show memory Shows memory utilization parameters
show process cpu Shows CPU utilization parameters
This command enables the SNMPv3 engine and services for all
management clients (i.e., versions 1, 2c, 3). Use the no form to disable the
server.
S
YNTAX
[no] snmp-server
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#snmp-server
Console(config)#
This command defines community access strings used to authorize
management access by clients using SNMP v1 or v2c. Use the no form to
remove the specified community string.
S
YNTAX
snmp-server community string [ro | rw]
no snmp-server community string
string - Community string that acts like a password and permits
access to the SNMP protocol. (Maximum length: 32 characters, case
sensitive; Maximum number of strings: 5)
ro - Specifies read-only access. Authorized management stations
are only able to retrieve MIB objects.
rw - Specifies read/write access. Authorized management stations
are able to both retrieve and modify MIB objects.
– 773 –
| SNMP Commands
C 21
HAPTER
General SNMP Commands
Mode
GC
GC
PE
PE