Line; Table 53: Line Commands - Edge-Core ECS3510-28T Management Manual

| System Management Commands
C 20
HAPTER

Line

L
INE
line
You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).

Table 53: Line Commands

Command Function
line Identifies a specific line for configuration and starts the
line configuration mode
accounting exec Applies an accounting method to local console, Telnet
or SSH connections
authorization exec Applies an authorization method to local console,
Telnet or SSH connections
Sets the number of data bits per character that are
databits *
interpreted and generated by hardware
exec-timeout Sets the interval that the command interpreter waits
until user input is detected
login Enables password checking at login
Defines the generation of a parity bit
parity *
password Specifies a password on a line
password-thresh Sets the password intrusion threshold, which limits the
number of failed logon attempts
Sets the amount of time the management console is
silent-time
*
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the
thresh
speed Sets the terminal baud rate
*
stopbits Sets the number of the stop bits transmitted per byte
*
timeout login response Sets the interval that the system waits for a login
attempt
disconnect Terminates a line connection
terminal Configures terminal settings, including escape-
character, line length, terminal type, and width
show line Displays a terminal line's parameters
* These commands only apply to the serial port.
This command identifies a specific line for configuration, and to process
subsequent line configuration commands.
S
YNTAX
line {console | vty}
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
– 728 –
command
Mode
GC
LC
LC
LC
LC
LC
LC
LC
LC
LC
password-
LC
LC
LC
PE
PE
NE, PE