Edge-Core ECS3510-28T Management Manual page 221

CLI R
EFERENCES
◆ "Configuring IP Subnet VLANs" on page 1147
C U
OMMAND SAGE
Each IP subnet can be mapped to only one VLAN ID. An IP subnet
◆
consists of an IP address and a mask. The specified VLAN need not be
an existing VLAN.
When an untagged frame is received by a port, the source IP address is
◆
checked against the IP subnet-to-VLAN mapping table, and if an entry
is found, the corresponding VLAN ID is assigned to the frame. If no
mapping is found, the PVID of the receiving port is assigned to the
frame.
The IP subnet cannot be a broadcast or multicast IP address.
◆
When MAC-based, IP subnet-based, and protocol-based VLANs are
◆
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
P
ARAMETERS
These parameters are displayed:
IP Address – The IP address for a subnet. Valid IP addresses consist of
◆
four decimal numbers, 0 to 255, separated by periods.
Subnet Mask – This mask identifies the host address bits of the IP
◆
subnet.
VLAN – VLAN to which matching IP subnet traffic is forwarded.
◆
(Range: 1-4094)
Priority – The priority assigned to untagged ingress traffic.
◆
(Range: 0-7, where 7 is the highest priority; Default: 0)
W I
EB NTERFACE
To map an IP subnet to a VLAN:
Click VLAN, IP Subnet.
1.
Select Add from the Action list.
2.
Enter an address in the IP Address field.
3.
Enter a mask in the Subnet Mask field.
4.
Enter the identifier in the VLAN field. Note that the specified VLAN need
5.
not already be configured.
Enter a value to assign to untagged frames in the Priority field.
6.
Click Apply.
7.
– 221 –
| VLAN Configuration
C 6
HAPTER
Configuring IP Subnet VLANs