F
IP A
ILTERING
DDRESSES FOR
W
I
EB
NTERFACE
To display the ARP Inspection log:
Click Security, ARP Inspection.
1.
Select Show Information from the Step list.
2.
Select Show Log from the Action list.
3.
Figure 206: Displaying the ARP Inspection Log
M
ANAGEMENT
Use the Security > IP Filter page to create a list of up to 15 IP addresses or
IP address groups that are allowed management access to the switch
through the web interface, SNMP, or Telnet.
CLI R
EFERENCES
"Management IP Filter" on page 855
◆
C
U
OMMAND
SAGE
The management interfaces are open to all IP addresses by default.
◆
Once you add an entry to a filter list, access to that interface is
restricted to the specified addresses.
◆
If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
IP address can be configured for SNMP, web and Telnet access
◆
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
When entering addresses for the same group (i.e., SNMP, web or
◆
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
◆
You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
– 379 –
C
HAPTER
Filtering IP Addresses for Management Access
A
CCESS
| Security Measures
13