Edge-Core ECS3510-28T Management Manual page 846

| Authentication Commands
C 23
HAPTER
802.1X Port Authentication
dot1x
re-authentication
dot1x timeout
quiet-period
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x port-control auto
Console(config-if)#
This command enables periodic re-authentication for a specified port. Use
the no form to disable re-authentication.
S
YNTAX
[no] dot1x re-authentication
C M
OMMAND ODE
Interface Configuration
C U
OMMAND SAGE
The re-authentication process verifies the connected client's user ID
◆
and password on the RADIUS server. During re-authentication, the
client remains connected the network and the process is handled
transparently by the dot1x client software. Only if re-authentication
fails is the port blocked.
The connected client is re-authenticated after the interval specified by
◆
the dot1x timeout re-authperiod
seconds.
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
R C
ELATED OMMANDS
dot1x timeout re-authperiod (847)
This command sets the time that a switch port waits after the maximum
request count (see page
acquire a new client. Use the no form to reset the default.
S
YNTAX
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
D
EFAULT
60 seconds
– 846 –
command. The default is 3600
844) has been exceeded before attempting to