Snmp-Server User - Edge-Core ECS3510-28T Management Manual

E
This command adds a user to an SNMP group, restricting the user to a

snmp-server user

specific SNMP Read, Write, or Notify View. Use the no form to remove a
user from an SNMP group.
S
D
None
C
Global Configuration
C
◆
XAMPLE
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
YNTAX
snmp-server user username groupname [remote ip-address]
{v1 | v2c | v3 [encrypted] [auth {md5 | sha} auth-password
[priv des56 priv-password]]
no snmp-server user username {v1 | v2c | v3 | remote}
username - Name of user connecting to the SNMP agent.
(Range: 1-32 characters)
groupname - Name of an SNMP group to which the user is assigned.
(Range: 1-32 characters)
remote - Specifies an SNMP engine on a remote device.
ip-address - IPv4 or IPv6 address of the remote device.
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
encrypted - Accepts the password as encrypted input.
auth - Uses SNMPv3 with authentication.
md5 | sha - Uses MD5 or SHA authentication.
auth-password - Authentication password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password. (A minimum of eight characters is required.)
priv des56 - Uses SNMPv3 with privacy with DES56 encryption.
priv-password - Privacy password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password.
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
Local users (i.e., the command does not specify a remote engine
identifier) must be configured to authorize management access for
SNMPv3 clients, or to identify the source of SNMPv3 trap messages
sent from the local switch.
– 783 –
| SNMP Commands
C 21
HAPTER
SNMPv3 Commands