Edge-Core ECS3510-28T Management Manual page 1078

| Spanning Tree Commands
C 33
HAPTER
spanning-tree
port-bpdu-flooding
spanning-tree
port-priority
R C
ELATED OMMANDS
spanning-tree mst cost (1076)
This command floods BPDUs to other ports when spanning tree is disabled
globally or disabled on a specific port. Use the no form to restore the
default setting.
S
YNTAX
[no] spanning-tree port-bpdu-flooding
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
When enabled, BPDUs are flooded to all other ports on the switch or to
◆
all other ports within the receiving port's native VLAN as specified by
the spanning-tree system-bpdu-flooding
The spanning-tree system-bpdu-flooding
◆
BPDU flooding is disabled on a port by the spanning-tree port-bpdu-
flooding command.
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-bpdu-flooding
Console(config-if)#
This command configures the priority for the specified interface. Use the
no form to restore the default.
S
YNTAX
spanning-tree port-priority priority
no spanning-tree port-priority
priority - The priority for a port. (Range: 0-240, in steps of 16)
D S
EFAULT ETTING
128
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
– 1078 –
command.
command has no effect if