Configuring Pppoe Ia Interface Settings - Edge-Core ECS3510-28T Management Manual

| IP Services
C 16
HAPTER
Configuring the PPPoE Intermediate Agent
C
ONFIGURING
PPP E IA I
O NTERFACE
S
ETTINGS
Figure 351: Configuring Global Settings for PPPoE Intermediate Agent
Use the IP Service > PPPoE Intermediate Agent (Configure Interface) page
to enable PPPoE IA on an interface, set trust status, enable vendor tag
stripping, and set the circuit ID and remote ID.
CLI R
EFERENCES
"PPPoE Intermediate Agent" on page 858
◆
P
ARAMETERS
These parameters are displayed:
Interface – Port or trunk selection.
◆
PPPoE IA Status – Enables the PPPoE IA on an interface.
◆
(Default: Disabled)
Note that PPPoE IA must also be enabled globally on the switch for this
command to take effect.
Trust Status – Sets an interface to trusted mode to indicate that it is
◆
connected to a PPPoE server. (Default: Disabled)
Set any interfaces connecting the switch to a PPPoE Server as
■
trusted. Interfaces that connect the switch to users (PPPoE clients)
should be set as untrusted.
At least one trusted interface must be configured on the switch for
■
the PPPoE IA to function.
◆ Vendor Tag Strip – Enables the stripping of vendor tags from PPPoE
Discovery packets sent from a PPPoE server. (Default: Disabled)
This parameter only applies to trusted interfaces. It is used to strip off
vendor-specific tags (which carry subscriber and line identification
information) in PPPoE Discovery packets received from an upstream
PPPoE server before forwarding them to a user.
– 600 –