Displaying Mvr Receiver Groups - Edge-Core ECS3510-28T Management Manual

| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv4
D MVR
ISPLAYING
R G
ECEIVER ROUPS
Select an MVR domain.
4.
Select the port or trunk for which to display this information.
5.
Figure 392: Showing the Static MVR Groups Assigned to a Port
Use the Multicast > MVR (Show Member) page to show the multicast
groups either statically or dynamically assigned to the MVR receiver groups
on each interface.
CLI R
EFERENCES
"show mvr" on page 1258
◆
P
ARAMETERS
These parameters are displayed:
Domain ID – An independent multicast domain. (Range: 1-5)
◆
Group IP Address – Multicast groups assigned to the MVR VLAN.
◆
VLAN – The VLAN through which the service is received. Note that this
◆
may be different from the MVR VLAN if the group address has been
statically assigned.
Port – Shows the interfaces with subscribers for multicast services
◆
provided through the MVR VLAN.
Up Time – Time this service has been forwarded to attached clients.
◆
Expire – Time before this entry expires if no membership report is
◆
received from currently active or new clients.
Count – The number of multicast services currently being forwarded
◆
from the MVR VLAN.
– 652 –