Edge-Core ECS3510-28T Management Manual page 847

C
OMMAND
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
This command sets the time period after which a connected client must be
dot1x timeout
re-authenticated. Use the no form of this command to reset the default.
re-authperiod
S
YNTAX
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
D
EFAULT
3600 seconds
C
OMMAND
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
This command sets the time that an interface on the switch waits for a
dot1x timeout
response to an EAP request from a client before re-transmitting an EAP
supp-timeout
packet. Use the no form to reset to the default value.
S
YNTAX
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
D
EFAULT
30 seconds
C
OMMAND
Interface Configuration
M
ODE
seconds - The number of seconds. (Range: 1-65535)
M
ODE
seconds - The number of seconds. (Range: 1-65535)
M
ODE
– 847 –
| Authentication Commands
C 23
HAPTER
802.1X Port Authentication