Automatic Code Upgrade Commands; Upgrade Opcode Auto - Edge-Core ECS3510-28T Management Manual

Automatic Code Upgrade Commands

upgrade opcode
auto
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
Console#whichboot
File Name
-------------------------------- ------- ------- ------------------- ----------
Unit 1:
ecs3510_28t_v1.4.0.0.bix
startup1.cfg
Console#
This command automatically upgrades the current operational code when a
new version is detected on the server indicated by the
path command. Use the no form of this command to restore the default
setting.
S
YNTAX
[no] upgrade opcode auto
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command is used to enable or disable automatic upgrade of the
◆
operational code. When the switch starts up and automatic image
upgrade is enabled by this command, the switch will follow these steps
when it boots up:
It will search for a new version of the image at the location specified
1.
by upgrade opcode path
stored on the TFTP server must be ecs3510-series.bix. If the switch
detects a code version newer than the one currently in use, it will
download the new image. If two code images are already stored in
the switch, the image not set to start up the system will be
overwritten by the new version.
After the image has been downloaded, the switch will send a trap
2.
message to log whether or not the upgrade operation was
successful.
– 723 –
| System Management Commands
C 20
HAPTER
Type Startup Modify Time
OpCode Y 2012-11-26 10:39:57
Config Y 2013-10-04 07:20:11
command. The name for the new image
File Management
Size(bytes)
14112484
1618
upgrade opcode